摘要
1Cr11Co3W3NiMoVNbNB为日本进口的新型高强度马氏体耐热钢,与传统的12Cr耐热钢相比,W、Co元素含量增至3%,使得该钢具有更好的高温持久强度和抗蠕变性能,但焊接性差。对1Cr11Co3W3NiMoVNbNB耐热钢的焊接性进行分析研究,并分别进行了斜Y型坡口抗裂试验和插销试验。结果表明,随着预热温度的提高,其斜Y型坡口焊接裂纹率逐渐下降,焊前不预热插销试样断口为沿晶+穿晶断裂形貌,当预热温度达到300℃时,断口为韧性断裂形貌。随着预热温度的升高,该材料的焊接冷裂纹敏感性下降。
1Cr11Co3W3NiMoVNbNB imported from Japan for the new high-strength martensitic heat-resistant steel,compared with the traditional 12Cr heat-resistant steel,W,Co elemental content increased to 3%,making the steel has better high-temperature lasting strength,creep resistance,but the weldability is deteriorated. In this paper,research on the weldability of 1Cr11Co3W3NiMoVNbNB heat-resisting steel,and conducts oblique Y-groove and cold-plug test respectively. The results show that the preheating temperature is increased,the welding crack rate of oblique Y-groove is gradually decreased,and the preheated bolt sample is not preheated to be intergranular and transgranular fracture morphology. When the preheating temperature reaches 300 ℃,the fracture is ductile fracture morphology. As the preheat temperature increases,the material's cold cracking sensitivity decreases.
引文
[1]陈伯蠡.金属焊接性基础[M].北京:机械工业出版社,1982.
[2]王锬.怎样防止寒极热裂纹[M].北京:机械工业出版社,1987.
[3]芮树祥,忻鼎乾.焊接工艺学[M].哈尔滨:哈尔滨工程大学出版社,1998.
[4]吴世初.金属的可焊性试验[M].上海:上海科学技术文献出版社,1983.
[5]Roosz A,Halder E,Exner H E.Numerical analysis of solid and liquid diffusion in microsegregation of binary alloys[J].Materials science and technology,1985,1(12):1057-1062.
[6]Roosz A,Halder E,Exner H E.Numerical calculation of microsegregation in coarsened dendritic microstructures[J].Materials science and technology,1986,2(11):1149-1155.
[7]Yeum K S,Laxmanan V,Poirier D R.Efficient estimation of diffusion during dendritic solidification[J].Metallurgical Transactions A,1989,20(12):2847-2856.
[8]Pustal B,Ludwig A,Sahm P R,et al.Simulation of macroscopic solidification with an incorporated one-dimensional microsegregation model coupled to thermodynamic software[J].Metallurgical and Materials Transactions B,2003,34(4):411-419.