摘要
温岭市观岙污水处理厂现有一期工程的规模为7×104m3/d,采用氧化沟工艺,出水水质执行国家二级排放标准。通过系统化的工艺诊断发现,一期工艺的脱氮除磷效果不甚理想,出水NH3-N、TN和TP浓度不能稳定达到未来的一级B标准要求。因此,建议修理或更换表曝机及相关主要设备、调整工艺运行参数、改造成A/O工艺、增加化学除磷单元。同时,对二期扩建工程的生物智能控制系统进行了研究,从合理的管路布置和管径大小、精确的在线仪表、优良的鼓风供气系统三方面提出了功能实现要求,以期达到生物工艺过程控制和节能减排。
The first-phase project of Wenling Guan'ao WWTP,with the capacity of 7 × 104m3/ d,adopted the oxidation ditch process to meet the national second level discharge standard.The systematic process diagnosis showed that nitrogen and phosphorus removal efficiency in the first-phase project was too low to meet the first level B criteria.The consequent recommendations were to repair or replace surface aerators and related major equipment,adjust process operating parameters,change into A / O process and add chemical phosphorus removal unit.Moreover,the bioprocess intelligent control system would be applied to realize process control,emission reduction and energy saving in the second-phase project.The system would perform better with reasonable pipe layout and pipe sizing,accurate online analyzers and excellent blower system.
引文
[1]段连钧,刘杰,谷兆全,等.传统活性污泥工艺升级改造的设计优化研究[J].中国给水排水,2010,26(11):43-46.
[2]胡志荣,周军,甘一萍,等.基于BioWin的污水处理工艺数学模拟与工程应用[J].中国给水排水,2008,24(4):19-23.
[3]贾晓燕.废水除磷技术的研究进展[J].重庆环境科学,2003,25(12):191-192.
[4]张波,陶明清,吴春笃,等.化学强化生物除磷工艺及设计[J].水处理技术,2006,32(10):87-89.
[5]虞正平.苏州福星污水厂改造方案的可行性分析[J].中国给水排水,2011,27(9):1-4.
[6]郭鹏飞,仲巍巍,史维忻,等.扬州六圩污水厂智能优化控制系统调试与运行[J].中国给水排水,2012,28(9):5-8.