Self-Sustaining Smoldering Combustion: A Novel Remediation Process for Non-Aqueous-Phase Liquids in Porous Media

详细信息    查看全文

• 作者：C. Switzer ; P. Pironi ; J.I. Gerhard ; G. Rein ; J.L. Torero
• 刊名：Environmental Science & Technology
• 出版年：2009
• 出版时间：August 1, 2009
• 年：2009
• 卷：43
• 期：15
• 页码：5871-5877
• 全文大小：262K
• 年卷期：v.43,no.15(August 1, 2009)
• ISSN：1520-5851

文摘

Smoldering combustion, the slow burning process associated typically with porous solids (e.g., charcoal), is here proposed as a novel remediation approach for nonaqueous phase liquids (NAPLs) embedded in porous media. Several one-dimensional vertical smoldering experiments are conducted on quartz sand containing fresh coal tar at an initial concentration of 71000 mg/kg (approximately 25% saturation) and employing an upward darcy air flux of 4.25 cm/s. Following a short-duration energy input to achieve ignition at the lower boundary, a self-sustaining combustion front is observed to propagate upward at 1.3 × 10⁻² cm/s. The process is self-sustaining because the energy released during NAPL smoldering is efficiently trapped and recirculated by the soil matrix, preheating the NAPL ahead of the reaction front. The smoldering process is observed to self-terminate when all of the NAPL is destroyed or when the oxygen source is removed. Pre- and post-soil analysis revealed that NAPL smoldering reduced the concentration of total extractable petroleum hydrocarbons (TPH) from 38000 mg/kg to below detection limits (<0.1 mg/kg) throughout the majority of the column. A comparable experiment in which conductive heating is applied in the absence of smoldering demonstrates a 6-fold reduction in the net energy in the system and residual TPH values of 2000−35000 mg/kg. A further repeat in which the air supply is prematurely terminated demonstrated that the NAPL smoldering process can be extinguished via external control. A suite of 23 demonstration experiments shows that NAPL smoldering is successful across a range of soil types (including simple layered systems) and contaminants (including laboratory mixtures of dodecane, DCA/grease, TCE/oil, vegetable oil, crude oil, and mineral oil) as well as field-obtained samples of materials containing coal tar, oil drill cutting waste, and oil sands.