用二安替比林甲烷紫外分光光度测定法测定铁矿石和相关材料中钛含量的标准试验方法

详细信息   

• 标准号：ASTM E878-2012
• 发布日期：2012
• 英文题名：Standard Test Method for Determination of Titanium in Iron Ores and Related Materials by Diantipyrylmethane Ultraviolet Spectrophotometry
• 英文主题词：diantipyrylmethane ; iron ore ; photometric titanium ; spectrophotometry ; titanium
• 标准状态：现行
• 发布单位：US-ASTM
• 国际标准分类号：73.060.10
• 载体形态：4P.;A4
• 国别：美国材料与试验协会

文摘

This test method is intended to be used for compliance with compositional specifications for titanium content. It is assumed that all who use these procedures will be trained analysts capable of performing common laboratory procedures skillfully and safely. It is expected that work will be performed in a properly equipped laboratory and that proper waste disposal procedures will be followed. Appropriate quality control practices must be followed such as those described in Guide E882.

1.1 This test method covers the determination of titanium in iron ores, concentrates, and agglomerates in the compositional range from 0.01 % to 6.0 % titanium.

Note 18212;As used in this test method (except as related to the term relative standard deviation), percent or x201C;%x201D; refers to mass fraction (wt/wt) of the form g/100g.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This test method has been evaluated in accordance with Practice E1601 and Guide E1763. Unless otherwise noted in 13, the lower limit in the scope of each method specifies the lowest analyte content that may be analyzed with acceptable error (defined as a nominal 5 % risk of obtaining a 50 % or larger relative difference in results on the same test sample in two laboratories).

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.