Physics‐based RF/microwave characterization of wave interactions within electrical connectors with partial insertion faults

详细信息    查看全文

• 作者：Çağatay Tokgöz ; Sameh Dardona
• 刊名：Radio Science
• 出版年：2016
• 出版时间：September 2016
• 年：2016
• 卷：51
• 期：9
• 页码：1489-1502
• 全文大小：1.5MB
• ISSN：1944-799X

文摘

Electrical failures in avionics systems may result from connector faults. If fault precursors are not detected in advance, they may lead to hard failures such as open and short circuits that could ultimately result in fire or loss of flight critical systems. Therefore, It is crucial to detect, locate, and characterize fault precursors for timely preventive maintenance and mitigation before hard failures occur. In this paper, a physics-based connector model consisting of multiple coaxial line sections with different characteristic impedances and lengths is proposed. Method of Moments (MoM) analyses were performed using commercial electromagnetic simulation software, FEKO, for transverse electric and magnetic (TEM) wave propagation through a connector. The physical parameters of the connector were optimized to match the measured S parameters for multiple insertion depths. The proposed models represent the connector for multiple insertion depths by varying only two length parameters at a time while other parameters are fixed. Insertion depth-dependent resonant frequency shifts observed during measurement are also captured by the model over the full range of fully inserted to barely touching contacts. Hence, the models provide accurate representations of the connector and properly detect precursors to partial insertion faults.