Geometric optimization of a convective T-shaped cavity on the basis of constructal theory

详细信息    查看全文

• 作者：G. Lorenzini ; C. Biserni ; F.L. Garcia ; L.A.O. Rocha
• 关键词：Constructal theory ; Geometric optimization ; T-shaped cavity ; Convection heat transfer
• 刊名：International Journal of Heat and Mass Transfer
• 出版年：2012
• 出版时间：November, 2012
• 年：2012
• 卷：55
• 期：23-24
• 页码：6951-6958
• 全文大小：932 K

文摘

The aim of this paper is to optimize, by means of Bejan¡¯s theory, the geometry of a T-shaped cavity that intrudes into a solid conducting wall. One direction in which the optimization of intrusion geometry can be pursued is that of increasing the complexity of the growing structures. When the heat generated by the volume is removed through one port, and when the smallest volume element size is fixed, the optimization of geometry generates a tree-shaped flow structure. The simplest tree-shaped structure is a ¡®first construct¡¯, or an optimized assembly of elemental volumes. The simplest first construct is the T-shaped tree here treated. The cavity is cooled by a steady stream of convection while the solid generates heat uniformly and it is insulated on the external perimeter. The structure has four degrees of freedom: L₀/L₁ (ratio between the lengths of the stem and bifurcated branches), H₁/L₁ (ratio between the thickness and length of the bifurcated branches), H₀/L₀ (ratio between the thickness and length of the stem) and H/L (ratio between the height and length of the conducting solid wall) and one restriction, the ratio between the cavity volume and solid volume (?). The purpose of the numerical investigation is to minimize the maximal dimensionless excess of temperature between the solid and the cavity. The simulations were performed for the following values of the cavity volume fractions (after having fixed H/L = 1): ? = 0.05, 0.1, 0.2 and 0.3. The first optimization, referred to the degree of freedom L₀/L₁, highlighted one ¡°intermediate¡± optimal shape, i.e., the best geometry was not obtained for the extremes values of L₀/L₁. As for the degree of freedom H₁/L₁, the optimal geometries were obtained for lowest ratio of H₁/L₁. Finally, when compared to the C-shaped cavity, i.e. the basic configuration, the T-shaped cavity performs approximately 45 % better under the same thermal and geometric conditions.