Anti-corrosion Wear-resistant Coatings on Parts of Oil Field Equipment

详细信息    查看全文

• 作者：E.N. Eremin^a ; ^{weld_techn@mail.ru" class="auth_mail" title="E-mail the corresponding author} ; V.M. Yurov^b ; M.K. Ibatov^c ; S.A. Guchenko^b ; V.Ch. Laurynas^b
• 关键词：anti-corrosion coating ; wear-resistant coating ; composite cathode ; nanohardness ; cellular structure
• 刊名：Procedia Engineering
• 出版年：2016
• 出版时间：2016
• 年：2016
• 卷：152
• 期：Complete
• 页码：594-600
• 全文大小：478 K

文摘

The paper reports on the preparation of ion-plasma anti-corrosion and wear-resistant coatings Cr-Mn-Si-Cu-Fe-Al and Cr-Mn-Si-Cu-Fe-Al-Ti. The first coating is prepared using the composite cathode. The second coating is prepared by simultaneous sputtering of composite and titanium cathodes in nitrogen atmosphere. In both cases the cellular microstructure of coatings is observed. The nanohardness of coating Cr-Mn-Si-Cu-Fe-Al, which is 7.4 GPa, is nearly two times as high as the nanohardness of titanium being 4.1 GPa and almost the same as for multilayer film Ti/α-C:Н which is 8.0 GPa. The corrosion rate in sulfuric acid (53 wt.%) is about 0.02 mm/year. The nanohardness of coating Cr-Mn-Si-Cu-Fe-Al+Ti, being 14.2 GPa, is nearly equal to the nanohardness of amorphous ribbon Zr-Cu-Ti-Ni, being 14.5 GPa or silicon (100), which is 14.8 GPa. The corrosion rate in sulfuric acid (53 wt.%) is less than 0.01 mm/year. The multilayer film of Ti/α-C:Н and amorphous tape Zr-Cu-Ti-Ni are used as abrasives, but their preparation is ten times more expensive than the proposed coatings.