Near dry electrical discharge machining

详细信息    查看全文

• 作者：C.C. Kao ; Jia Tao ; Albert J. Shih
• 关键词：Near dry machining ; Electrical discharge machining ; Material removal rate ; Dielectric strength
• 刊名：International Journal of Machine Tools and Manufacture
• 出版年：2007
• 出版时间：December 2007
• 年：2007
• 卷：47
• 期：15
• 页码：2273-2281
• 全文大小：520 K

文摘

This study investigates the near dry electrical discharge machining (EDM) process. Near dry EDM uses liquid–gas mixture as the two phase dielectric fluid and has the benefit to tailor the concentration of liquid and properties of dielectric medium to meet desired performance targets. A dispenser for minimum quantity lubrication (MQL) is utilized to supply a minute amount of liquid droplets at a controlled rate to the gap between the workpiece and electrode. Wire EDM cutting and EDM drilling are investigated under the wet, dry, and near dry conditions. The mixture of water and air is the dielectric fluid used for near dry EDM in this study. Near dry EDM shows advantages over the dry EDM in higher material removal rate (MRR), sharper cutting edge, and less debris deposition. Compared to wet EDM, near dry EDM has higher material removal rate at low discharge energy and generates a smaller gap distance. However, near dry EDM places a higher thermal load on the electrode, which leads to wire breakage in wire EDM and increases electrode wear in EDM drilling. A mathematical model, assuming that the gap distance consists of the discharge distance and material removal depth, was developed to quantitatively correlate the water–air mixture's dielectric strength and viscosity to the gap distance.