Optimizing inkjet printing process to fabricate thick ceramic coatings

详细信息    查看全文

• 作者：S.H. Rahul^a ; ^{sh.rahul@outlook.com} ; K. Balasubramanian^a ; Sriram Venkatesh^b
• 关键词：YSZ ; Yttria stabilized Zirconia ; IJP ; Inkjet Printing ; DOD ; Drop on Demand
• 刊名：Ceramics International
• 出版年：2017
• 出版时间：1 April 2017
• 年：2017
• 卷：43
• 期：5
• 页码：4513-4519
• 全文大小：854 K
• 卷排序：43

文摘

This article describes the use of Taguchi optimization and ANOVA techniques on inkjet printing process to determine optimal parameters for fabrication of thick ceramic coatings over glass substrates. Stable nanoparticle suspensions are synthesized through high energy milling of precursor powders with adequate quantities of binder and suspending solvent. Most often, inkjet printing process is being used for developing fine and thin layers (<10 µm). However, an attempt is made to fabricate thick ceramic films by varying only IJP process parameters and without multiple layer deposition, thereby reducing efforts in ink synthesis and processing time of coated substrates. Three parameters of IJP were varied for developing a model that was used for precisely predicting the printed layer thickness under varying process parameters. ANOVA technique showed that open time interval in combination with nano particle concentration in the ink could potentially lead to thick coatings. The higher volume % of solvent in the diluted suspension ink under the influence of substrate heating contributed significantly to coffee stain effect with irregular surface coatings. However, increasing the concentration of nanoparticles in the diluted ink resulted in substantial improvement in thickness of the layer with simultaneous control of coating defects.