Local and overall wind pressure and force coefficients for solar panels

详细信息    查看全文

• 作者：Ted Stathopoulos ; Ioannis Zisis ; Eleni Xypnitou
• 关键词：Codes and standards ; Force coefficient ; Ground level ; Low-rise building ; Photovoltaic panel ; Pressure coefficient ; Rooftop ; Design ; Solar collector ; Wind tunnel
• 刊名：Journal of Wind Engineering and Industrial Aerodynamics
• 出版年：February, 2014
• 年：2014
• 卷：125
• 期：Complete
• 页码：195-206
• 全文大小：3018 K

文摘

This paper reports on an experimental study carried out to better understand the wind pressure distribution on stand-alone panel surfaces and panels attached to flat building roofs. A complex model capable to incorporate solar panels at different locations and various inclinations was constructed at a 1:200 geometric scale. Three model panels equipped with pressure taps on both surfaces (36 in total) for point and area-averaged pressure measurements were used. Pressure and force coefficients were computed for every pressure tap and for all the panels. Different configurations were tested under similar conditions in order to examine the effect of various parameters on the experimental results. A minimal gap occurred between the solar panels and the roof of the model. The study found that the net values of pressure coefficients corresponding to different configurations are affected by the panel inclination for the critical 135掳 wind direction, for which panels on the back location undergo higher suctions in comparison to those in the front. The effect of building height on the solar collector total load is minimal, whereas corner panels are subjected to higher net loads for critical azimuths. Simplified net pressure coefficients for the design of solar panels are provided.