Grain size versus microstructural stability in the high strain rate superplastic response of a severely friction stir processed Al-Zn-Mg-Cu alloy

详细信息    查看全文

• 关键词：Aluminum alloys ; Friction stir processing ; Grain refinement ; Low temperature high strain rate superplasticity ; Microstructural stability
• 刊名：Materials Science and Engineering: A
• 出版年：2017
• 出版时间：5 January 2017
• 年：2017
• 卷：680
• 期：Complete
• 页码：329-337
• 全文大小：2087 K
• 卷排序：680

文摘

An Al-Zn-Mg-Cu, Al 7075, alloy in an overaged state was subjected to friction stir processing (FSP) using a wide range of processing conditions. The goal was to diminish the heat index, increasing therefore the processing severity. Additionally, two backing anvils were selected that strongly influence the heat extraction rate. Grain sizes obtained by transmission electron microscopy were situated in the range 210–820 nm. High temperature tensile tests and the scanning electron micrographs of the topography of the tensile samples after testing revealed that grain boundary sliding (GBS) operated at an initial strain rate of ε̇=10−2 s−1 in a wide range of temperatures for the processed alloy. That temperature window was wider and situated at lower temperatures for the finer grain sizes. The high processing severity imposed to create such fine microstructures introduces high values of stored energy in the material, which is the driving force for the increasing grain coarsening at high temperatures. This fact limited the operation of GBS at the highest tested temperatures in some conditions. An optimum balance between grain refinement and microstructural stability was obtained using a low heat index, corresponding to the processing conditions of ω=1000 rpm, V =500 mm/min, and the use of refrigerated backing anvil.