文摘
Vanadium oxide (V2O5) is a multifaceted material possessing desirable redox properties, including accessibility to multiple valence states, which make it attractive as a cathode for lithium ion batteries and microbatteries. Studies show that performance of this electrode material is dependent on the electrolyte employed and that solid electrolyte interphase (SEI) layer formation is responsible for the fade in capacity with multiple cycling. Nanostructured V2O5 thin films synthesized through reactive ballistic deposition (RBD) were studied with electrochemical methods, ex situ Raman and ex situ XPS in two widely used electrolytes: LiClO4/propylene carbonate (PC) and LiPF6/diethyl carbonate (DEC) + ethylene carbonate (EC). Films cycled in LiPF6/DEC+EC experienced a 32% greater capacity fade between the first and second lithiathion/delithiation cycles than those cycled in LiClO4/PC, due to a redox-induced change in the surface morphology and composition and an irreversible transformation into an amorphous state as monitored by ex situ Raman. From X-ray photoelectron spectroscopy (XPS), it was shown that V2O5 cycled in LiPF6/DEC+EC contained a high atomic concentration percentage of fluoride (16.18%) in comparison with V2O5 electrodes cycled in LiClO4/PC (3.94%). No significant amounts of carbonates, oxalates, or oxyfluorophosphates typically associated with SEI formation were found when V2O5 was cycled in either electrolyte. The results obtained suggest instead that HF, formed upon water contamination of the electrolyte, reacts with V2O5 through a self-catalyzed process both at open circuit and under applied potential. The formation of vanadium oxyfluorides causes active mass loss and severe capacity fade upon discharging/charging.