The Effect of finite strain and deformation history of HALABAN area, eastern Arabian shield, Saudi Arabia

详细信息    查看全文

• 作者：Yousef A. Al-Amri ; Osama M. K. Kassem
• 关键词：Finite strain ; Deformation ; Halaban area ; Arabian shield ; Saudi Arabia
• 刊名：Arabian Journal of Geosciences
• 出版年：2017
• 出版时间：January 2017
• 年：2017
• 卷：10
• 期：2
• 全文大小：
• 刊物类别：Earth and Environmental Science
• 刊物主题：Earth Sciences, general;
• 出版者：Springer Berlin Heidelberg
• ISSN：1866-7538
• 卷排序：10

文摘

The present study aims to evaluate a relationship between the mineralogy and structural analysis in the Halaban area and to document the tectonic evolution of Halaban and Al Amar faults. The collected samples were taken from deformed granitiods rocks (such as granite, gneisses and tonalite), metasedimentary, metavolcanic, metagabbro and carbonate rocks are trend to NE-SW with low dip angle in the Halaban area. These samples were 8 from granite, 14 metagabbro, 6 metavolcanics, 5 tonalite, 6 metasedimentary, 10 gneisses and 8 carbonate rocks. Our results are described for the different axial ratios of deformed rocks as the following: XZ sections range from 1.10 to 4.60 in the Fry method and range from 1.70 to 2.71 in the Rf/ϕ method. YZ sections range from 1.10 to 3.34 in the Fry method and range from 1.62 to 2.63 in the Rf/Phi method. In addition, XY sections range from 1 to 3.51 in the Fry method and range from 1 to 1.27 in the Rf/ϕ method for deformed granite rocks, metasedimentry rocks, and metagabbro. The stretch axes for measured samples in the X direction axes (S_X) variety from 1.06 to 2.53 in the Fry method and vary from 1.20 to 1.45 in the Rf/ϕ method. The values of the Y direction axes (S_Y) vary from 0.72 to 1.43 in the Fry method, which indicates contraction and extension in this direction and vary from 1.13 to 1.37 in the Rf/ϕ method which indicates extension in this direction. Furthermore, the Z direction axes (SZ) varies from 0.09 to 0.89 in the Fry method and from 0.52 to 0.71 in the Rf/ϕ method. The stretches axes in the Z direction (SZ) show a vertical shortening about 11% to 91% in the Fry method and show vertical shortening about 29% to 48% in the Rf/ϕ method. The studied rock units are generally affected by brittle-ductile shear zones, which are sub-parallel to parallel NW or NNW trend. It assumed that different rock types of have similar deformation behavior. Based on these results, it is concluded that the finite strain is accumulated during the metamorphism after that was started the deformation by thrusting activity. The contacts between the different rock types were deformed during thrusting under semi-brittle to ductile deformation conditions by simple shear. A component of vertical shortening is also involved causing subhorizontal foliation in the Halaban area.