Facile fabrication of controllable zinc oxide nanorod clusters on polyacrylonitrile nanofibers via repeatedly alternating immersion method

详细信息    查看全文

• 作者：Ying Zhou ; Xia Li ; Hou-Yong Yu ; Guo-Liang Hu…
• 关键词：Composite nanofiber membranes ; Zinc oxide nanorod clusters ; Alternating immersion method ; Thermal stability ; Photocatalytic activity
• 刊名：Journal of Nanoparticle Research
• 出版年：2016
• 出版时间：December 2016
• 年：2016
• 卷：18
• 期：12
• 全文大小：
• 刊物类别：Chemistry and Materials Science
• 刊物主题：Nanotechnology; Inorganic Chemistry; Characterization and Evaluation of Materials; Physical Chemistry; Optics, Lasers, Photonics, Optical Devices;
• 出版者：Springer Netherlands
• ISSN：1572-896X
• 卷排序：18

文摘

Polyacrylonitrile/zinc oxide (PAN/ZnO) composite nanofiber membranes with different ZnO morphologies were fabricated by repeatedly alternating hot–cold immersion and single alternating hot–cold immersion methods. The influence of the PAN/ZnCl₂ ratio and different immersion methods on the morphology, microstructure, and properties of the nanofiber membranes was investigated by using field-emission scanning electron microscopy (FE-SEM), Fourier-transform infrared spectroscopy (FT-IR), X-ray diffraction (XRD) analysis, thermogravimetric analysis (TGA), and ultraviolet–visible (UV–Vis) spectroscopy. A possible mechanism for different morphologies of PAN/ZnO nanofiber membranes with different PAN/ZnCl₂ ratio through different immersion processes was presented, and well-dispersed ZnO nanorod clusters with smallest average dimeter of 115 nm and hexagonal wurtzite structure were successfully anchored onto the PAN nanofiber surface for R-7/1 nanofiber membrane. Compared to S-5/1 prepared by single alternating hot–cold immersion method, the PAN/ZnO nanofiber membrane fabricated by repeatedly alternating hot–cold immersion method (especially for R-7/1) showed improved thermal stability and high photocatalytic activity for methylene blue (MB). Compared to S-5/1, decomposition temperature at 5% weight loss (T_5%) was increased by 43 °C from 282 to 325 °C for R-7/1; meanwhile, R-7/1 showed higher photocatalytic degradation ratio of approximately 100% (after UV light irradiation for 8 h) than 65% for S-5/1 even after irradiation for 14 h. Moreover, the degradation efficiency of R-7/1 with good reuse stability remained above 94% after 3 cycles.