Experimental investigation on the influence of engine operating conditions on combustion and nanoparticle emission characteristics of a small DI diesel engine

详细信息    查看全文

• 作者：Seung Hyun Yoon ; Su Han Park
• 刊名：Journal of Mechanical Science and Technology
• 出版年：2016
• 出版时间：June 2016
• 年：2016
• 卷：30
• 期：6
• 页码：2839-2848
• 全文大小：719 KB
• 刊物类别：Engineering
• 刊物主题：Mechanical Engineering
  Structural Mechanics
  Control Engineering
  Industrial and Production Engineering
  
• 出版者：The Korean Society of Mechanical Engineers
• ISSN：1976-3824
• 卷排序：30

文摘

The influence of variations in engine speed, injection pressure, injection timing, and multiple injection strategies on the combustion and nanoparticle characteristics of a small Direct injection (DI) diesel engine was experimentally investigated. To measure the size distribution and number concentration of particle emissions, a rotating disk thermo-diluter (dilution system), a Condensation particle counter (CPC), and a Scanning mobility particle sizer (SMPS) were used. The injection pressure was changed from 60 MPa to 120 MPa, at an engine speed of 1200 rpm. Injection timing was varied from Before top dead center (BTDC) 40˚ to Top dead center (TDC). To investigate the effect of multiple-injection strategies, the injection strategies consisted of two pulse signals with different dwell time. The experimental results show that the peak combustion pressure and Rate of heat release (ROHR) profile are increased and ignition delay is shortened with the increase of injection pressure from 60 MPa to 120 MPa. The concentration of soot emission for 120 MPa is lower than that of 60 MPa at advanced injection timing from TDC up to BTDC 25°. As the injection timing advances to over BTDC 30°, soot emissions rapidly increase and the high injection pressure case (120 MPa) creates more emissions than the 60 MPa case. The overall trends of total particle number are relatively increased with high injection pressure for single injection conditions. In the advanced injection timings of over BTDC 30°, the trend of total particle number is high for all injection pressures. For multiple injections, the peak combustion pressures and ROHR of multiple-injection strategies are slightly lower compared with those of single-combustion results. Comparing the multiple injection strategies, soot emission is reduced with the retard of second injection timing (-30°+5°). The overall trends of particle size and total number for the 7 mg+3 mg case revealed the lowest level compared with other cases, which is 50% lower than that for the 5 mg+5 mg case. When compared with single injection results, the total particle number and Dp of multiple injection cases were eventually lower.KeywordsCombustion characteristicsExhaust emissionsNanoparticleParticulate matterSoot