Assessment of the indoor air quality in copy centres at Aveiro, Portugal

详细信息    查看全文

• 作者：Estela D. Vicente ; João P. Ribeiro ; Danilo Custódio…
• 关键词：Indoor air quality ; Copy centre ; Particulate matter ; Ozone
• 刊名：Air Quality, Atmosphere & Health
• 出版年：2017
• 出版时间：March 2017
• 年：2017
• 卷：10
• 期：2
• 页码：117-127
• 全文大小：
• 刊物类别：Earth and Environmental Science
• 刊物主题：Environmental Health; Atmospheric Protection/Air Quality Control/Air Pollution; Health Promotion and Disease Prevention;
• 出版者：Springer Netherlands
• ISSN：1873-9326
• 卷排序：10

文摘

This study presents continuous measurements of size-segregated particulate matter, total volatile organic compounds, ozone, formaldehyde, comfort parameters (temperature and relative humidity), CO and CO₂ at two copy centres (A and B) in Aveiro, Portugal. PM₁₀ samples collected with low-volume samplers were used to determine the carbonaceous content (organic and elemental carbon) by a thermo-optical technique. Mean PM₁₀ levels of 55.8 ± 7.50 μg m−3 and 51.3 ± 9.35 μg m−3 were obtained in copy centres A and B, respectively. The 24-h indoor PM₁₀ concentration at both copy centres exceeded the protection limit established by the Portuguese legislation. Around 60 % of the PM₁₀ were composed of particles with sizes below 2.5 μm. On average, organic carbon accounted for 27.6 % (copy centre A) and 18.6 % (copy centre B) of the PM₁₀ mass indoors, whereas a lower mass fraction of 11.5 % was found for both outdoor spaces. The much higher indoor levels of organic carbon suggest significant contribution by indoor sources. The ozone level increased in both copy centres when the photocopiers started to work. Mean ozone levels (0.055 ± 0.005 and 0.048 ± 0.006 ppm in copy centres A and B, respectively) during business hours may exceed the standard recommended for workplaces (0.05 ppm), representing a cause of possible adverse health effects on employees. The indoor-to-outdoor ozone concentration ratios were greater than 1 in both centres, indicating an important contribution of indoor sources. Formaldehyde levels remained always below the World Health Organisation guideline for indoor air (0.1 mg m−3). Total concentrations of volatile organic compounds were also relatively low, in general ranging from around 190 to 300 ppb. The indoor-to-outdoor concentration ratios were in the range between 0.70 and 0.76. Results showed that operation of laser printers can lead to high particulate matter and ozone concentration indoors. Pollutants associated with printing equipment have potential to cause adverse health effects if exposures are sufficiently high. Precautions should be taken to minimise the risks of exposed workers.