管路结构振动能量传递规律研究
|
摘要
为研究管路系统中振动能量的传递规律,建立了2根半无限长管道结构的纵弯耦合振动模型,基于波分析法,分别研究了2根管道在各类不同的连接边界条件下,弯曲波振动传递规律。引入无量纲系数,简化方程组,推导出弯曲波入射时在不同边界条件下的反射及透射系数。通过数值分析得到了弯曲波入射条件下,参数变化对振动能量传递规律的影响,研究结果表明两管连接刚度主要影响高频振动,两管夹角主要影响低频振动,扭转刚度会使振动能量曲线产生波谷,且当扭转刚度值较低时,对低频振动影响较大,计算结果对管路结构在不同工况下连接参数的选择具有指导作用。
A longitudinal-bending coupled vibration model of two semi-infinite long pipelines is put out in this paper.Vibration energy transmission of two semi-infinite long pipelines is indicated by wave approach under different kinds of boundary conditions. Several non-dimensional coefficients are introduced to simplify the equations, and the reflection and transmission coefficients are derived. Through numerical analysis, the parameter change on the vibration energy transfer is obtained, under the bending wave incidence. The results show that the vibration energy transmission is mainly affected by connecting rigidity at high frequency, and mainly affected by the angle at low frequency, and the rotational rigidity will cause vibrational energy transmission curves to generate troughs and has influence at low frequency under low rotational rigidity,which can be useful to the selection of transmission shafts parameters.
A longitudinal-bending coupled vibration model of two semi-infinite long pipelines is put out in this paper.Vibration energy transmission of two semi-infinite long pipelines is indicated by wave approach under different kinds of boundary conditions. Several non-dimensional coefficients are introduced to simplify the equations, and the reflection and transmission coefficients are derived. Through numerical analysis, the parameter change on the vibration energy transfer is obtained, under the bending wave incidence. The results show that the vibration energy transmission is mainly affected by connecting rigidity at high frequency, and mainly affected by the angle at low frequency, and the rotational rigidity will cause vibrational energy transmission curves to generate troughs and has influence at low frequency under low rotational rigidity,which can be useful to the selection of transmission shafts parameters.
引文
[1]GRICE R M,PINNINGTON R J.A method for the vibration analysis of built-up structures,partⅠ:introduction and analytical analysis of the plate-stiffened beam[J].Journal of Sound and Vibration,2000,230(4):825-849.
[2]王川.海洋工程管路减振降噪研究[D].中国海洋大学,2015.
[3]潘国雄,张盛,周赤奇,等.管路阀组结构制造工艺参数的振动特性影响[J].舰船科学技术,2013,35(4):131-136.
[4]王勇,黄映云,吕志强,等.一种舰用管路振动传递控制的工程方法[J].舰船科学技术,2007(4):75-77+85.
[5]何琳,何世平.阻隔质量对杆类结构弯曲波隔离的工程应用研究[J].声学技术,2007(1):153-158.
[6]CREMER L,HECKL M,PETERSSON B A T.Structure-Borne Sound[M].Springer Berlin Heidelberg,2005.
[7]车驰东,陈端石.成任意角度连接的两块平板转角处阻振质量对平面弯曲波传递的影响分析[J].声学学报,2007(3):282-288.
[2]王川.海洋工程管路减振降噪研究[D].中国海洋大学,2015.
[3]潘国雄,张盛,周赤奇,等.管路阀组结构制造工艺参数的振动特性影响[J].舰船科学技术,2013,35(4):131-136.
[4]王勇,黄映云,吕志强,等.一种舰用管路振动传递控制的工程方法[J].舰船科学技术,2007(4):75-77+85.
[5]何琳,何世平.阻隔质量对杆类结构弯曲波隔离的工程应用研究[J].声学技术,2007(1):153-158.
[6]CREMER L,HECKL M,PETERSSON B A T.Structure-Borne Sound[M].Springer Berlin Heidelberg,2005.
[7]车驰东,陈端石.成任意角度连接的两块平板转角处阻振质量对平面弯曲波传递的影响分析[J].声学学报,2007(3):282-288.