GK型密炼机混炼室装配工艺的分析

详细信息    查看全文 | 推荐本文 |

英文篇名：Analysis of GK internal mixing chamber's assbemly process 作者：卜亚平 ; 金卿蕾 ; 成显南 英文作者：Bu Yaping;Jin Qinglei;Cheng Xiannan;Yiyang Rubber Plastic Machinery Group Co.LTD.; 关键词：混炼室 ; 混炼室刃口 ; 下顶栓 ; 轴承支架 英文关键词：mixing chamber;;chamber cutting edge;;lower ram;;bearing support 中文刊名：XJJZ 英文刊名：China Rubber/Plastics Technology and Equipment 机构：益阳橡胶塑料机械集团有限公司; 出版日期：2019-07-01 出版单位：橡塑技术与装备 年：2019 期：v.45;No.449 语种：中文; 页：XJJZ201913015 页数：3 CN：13 ISSN：11-4534/TQ 分类号：47-49

摘要

剖析了GK型密炼机关键件混炼室的装配工艺,分析了混炼室刃口与下顶栓斜面间隙处漏胶、漏粉的原因,并指出其改进思路。通过实例计算,指出原混炼室装配工艺中的不足之处,采取措施消除了不利的影响因素。经过不断优化完善,最后得到了一种新的混炼室装配工艺。
        This paper analyzes the assembly process of the key parts mixing chamber for GK internal mixer,and analyzes the causes of rubber leakage at the gap between the chamber cutting edge and lower ram slope, and pointed out the improvement ideas. Through the calculation of the example, the deficiencies in the assembly process of the original mixing chamber are pointed out, and measures are taken to eliminate the adverse influencing factors. After continuous optimization and improvement, a new mixing chamber assembly process was finally obtained.

引文