车床卡盘扳手安全防砸伤报警器
|
摘要
阐述了为普通车床设置安全保护装置的必要性,并进一步分析了卡盘扳手造成的安全事故的主观和客观因素。该设备通过金属触摸传感器检测车床夹头。当该模块与三爪卡盘接触时,信号被传送到Arduino的单片机发出警报。详细介绍了安全保护系统设计的工作原理和结构。
In this paper, the necessity of setting up safety protection device for common lathe is expounded, and the subjective and objective factors of safety accident caused by chuck wrench are further analyzed. The device detects the lathe chuck through a metal touch sensor. When the module is in contact with the three-claw chuck, the signal is transmitted to the Arduino microcontroller to issue an alarm. The working principle and structure of the safety protection system design are introduced in detail.
In this paper, the necessity of setting up safety protection device for common lathe is expounded, and the subjective and objective factors of safety accident caused by chuck wrench are further analyzed. The device detects the lathe chuck through a metal touch sensor. When the module is in contact with the three-claw chuck, the signal is transmitted to the Arduino microcontroller to issue an alarm. The working principle and structure of the safety protection system design are introduced in detail.
引文
[1]杜小玲,杨左.一般车床卡盘的联锁安全装置的必要性和使用效果[J].重庆工业学院学报,2005,02.
[2]罗太景.安全卡盘扳手设计与应用[J].机床与液压,2012(02):22-26.
[3]Zhang xin and pan wenlong.Safety protection of lathe chuck wrench.Design and application of protectivedevice/silicon valley/2013.0.
[4]Kadowaki.Yoshalsupu/DDEVELOPMENTOFCHUCKINGCONDITION SENSORFOR THREE-AWSCROLLCHUCK/Source Bulingth.SME,v29,n248.p625-631,Fb1986.
[5]刘国通.巧改车床两用安全扳手[J].金属加工,2017(03):42.
[6]索来春,苏健,梁艳超.卡盘电动扳手的设计[J].新技术新工艺,2006(07):38-39.
[7]陈冲峰.一种机床多功能扳手设计制作[J].机械工程师,2017(02):122-123.
[2]罗太景.安全卡盘扳手设计与应用[J].机床与液压,2012(02):22-26.
[3]Zhang xin and pan wenlong.Safety protection of lathe chuck wrench.Design and application of protectivedevice/silicon valley/2013.0.
[4]Kadowaki.Yoshalsupu/DDEVELOPMENTOFCHUCKINGCONDITION SENSORFOR THREE-AWSCROLLCHUCK/Source Bulingth.SME,v29,n248.p625-631,Fb1986.
[5]刘国通.巧改车床两用安全扳手[J].金属加工,2017(03):42.
[6]索来春,苏健,梁艳超.卡盘电动扳手的设计[J].新技术新工艺,2006(07):38-39.
[7]陈冲峰.一种机床多功能扳手设计制作[J].机械工程师,2017(02):122-123.