摘要
以大功率非能动压水堆为研究对象,采用MAAP程序研究RCS热管段5 cm小破口始发严重事故下IVR-ERVC对裂变产物释放的影响。结果表明,启动ERVC时安全壳内的Cs I质量份额约0. 29,释放到环境中的惰性气体和Cs I质量份额分别为0. 001 3,1. 95×10~(-5),不启动ERVC时安全壳内的Cs I质量份额约为0. 38,释放到环境中的惰性气体和Cs I质量份额分别为0. 94,2. 95×10~(-2)。大功率非能动压水堆严重事故后启动ERVC,能有效地将熔融物滞留在压力容器内,保持压力容器的完整,降低事故后惰性气体和Cs I向环境的释放量。
The effect of IVR-ERVC on the release of fission products was studied by MAAP code for the large power passive PWR under severe accident induced by 5 cm small break of the RCS heat pipe. The results indicated that when starting ERVC,29% of Cs I released into the containment,and the fraction of inert gas and Cs I released into the environment were 0. 001 3 and 1. 95 × 10~(-5)respectively. About 38% of Cs I released into the containment without ERVC,and the fraction of inert gas and Cs I released into the environment were 0. 94 and 2. 95 × 10~(-2)respectively.The ERVC can effectively retain the melt in the reactor pressure vessel,maintain the integrity of the reactor vessel and reduce the release of inert gas and Cs I to the environment after the severe accident for large power passive PWR.
引文
[1]赵国志.压水堆严重事故堆内熔融物滞留仿真研究[D].哈尔滨:哈尔滨工程大学,2014.
[2]金越.严重事故下大功率压水堆IVR-ERVC有效性MELCOR研究[D].上海:上海交通大学,2014.
[3]NEA.In-vessel core debris retention and coolability[R].NEA,Report,CNSI18,1998.
[4]T G Theofanous,C Liu,S Addition,et al.In-vessel coolability and retention of a core melt[R].DOE,Report,ID-10460,1996.
[5]R J Park,K S Ha,S B Kim,et al.Two-phase natural circulation flow of air and water in a reactor cavity model under an external vessel cooling during a severe accident[J].Nuclear Engineering and Design,2006,236:2424-2430.
[6]李飞,李永春,程旭.针对REPEC加热实验的RELAP5程序模拟与分析[J].原子能科学技术,2012,46(7):815-820.
[7]金頔.大功率先进压水堆压力容器外部自然循环冷却数值研究[D].上海:上海交通大学,2013.
[8]O Kymalainen,H Tuomisto,T G Theofanous.In-vessel retention of corium at the Loviisa plant[J].Nuclear Engineering and Design,1997,169:109-130.
[9]H Esmaili,M Khatib-Rahbar.Analysis of likelihood of lower head failure and ex-vessel fuel coolant interaction energetics for AP1000[J].Nuclear Engineering and Design,2005,235:1583-1605.
[10]林诚格,郁祖盛,欧阳予.非能动安全先进压水堆核电技术[M].北京:原子能出版社,2010.
[11]吴鹏.基于比较和参数敏感性分析的压水堆严重事故模型评价研究[D].上海:上海交通大学,2007.
[12]M Lee,Y C Ko.Quantification of severe accident source terms of a Westinghouse 3-loop plant[J].Nuclear Engineering and Design,2008,238:1080-1092.
[13]张琨.APl000核电厂大量放射性释放源项分析[J].原子能科学技术,2012,46(9):1107-1111.
[14]孙婧,马秀歌,陈巧艳.事故后安全壳内环境条件计算分析[J].南方能源建设,2015,2(4):53-56.