恒温晶体振荡器调频范围扩展研究
详细信息    本馆镜像全文|  推荐本文 |  |   获取CNKI官网全文
摘要
泛音晶体构成的恒温晶体振荡器(OCXO)具有优良的稳定度和老化指标,但是它的压控频率调节范围很窄,常常难以满足同时对上述指标都有较高要求的情况。尤其是高精度OCXO作为精密的可控频率源时,针对相对宽的频率比对范围OCXO需要能够在频率上被调试、控制,并且保持良好的频率稳定度、老化指标,这是未经过调频扩展的OCXO无法实现的。本文介绍了根据更宽的频率调节范围内采用对OCXO的控制温度进行调整的方法实现扩展频率范围,让恒温晶体振荡器在几个温度点实现分段恒温。
     本文中采用可程控电位器代替OCXO中控温电桥中的电阻,然后单片机根据锁相环给出的控制信号来控制可程控电位器输出电阻大小从而改变恒温晶体振荡器的恒温温度。通过改变恒温晶体振荡器的恒温温度使OCXO的输出频率改变,从而达到改变恒温晶体振荡器调频范围的目的。本文采用基于CPLD实现的数字锁相环,本锁相环具有锁定速度快、锁相精度高、锁相范围宽的特点。该锁相环可以判断恒温晶体振荡器和标频之间失锁的情况,在失锁情况下还可以给出表示恒温晶体振荡器和标频之间的频率高低关系的控制信号。利用锁相环给出的失锁控制信号,单片机判断并控制可程控电位器输出电阻值,从而改变恒温晶体振荡器的输出频率,最终达到恒温晶体振荡器和标频之间锁定的目的。该方案不仅保证了恒温晶体振荡器原来的频率稳定度,而且把原来的10-7量级的压控频率调节范围扩大到10-6量级甚至更好。
High precision oven control crystal oscillator (OXCO) based on overtone crystalscan show very high frequency stability, aging specifications. However, their frequencyregulation range by voltage control is not wide, and it is difficult to obtain all the goodperformances. Especially when high precision OCXO is used as the standard of precisecontrollable measuring instruments, in allusion to widen frequency comparison range,the precision OCXO should not only show nice frequency stability and aging, but alsocan be regulated and controlled in a relative wide frequency range. Using a fundamentalcrystal it is impossible to obtain this result. In allusion to wider frequency regulationrange, we propose a new method through regulating the control temperature of theOCXO to widen the frequency range, the temperature of the OCXO will keep in sometemperature segment.
     In this paper, a programmable potentiometer is used to substitute the resistor oftemperature-control Bridge. MCU changes the temperature of OCXO by changing theoutput resistor of the potentiometer with the control signal from PLL. The outputfrequency of OCXO will vary with the changing of the OCXO temperature, and thatwill change the output frequency of OCXO. The PLL is designed based on CPLD, thistype PLL has the quality of high precision, high speed locked and wide locked range.This type PLL can determine whether the PLL is locked or not, and it can provide thecontrol signal which can representative the frequency relation between the OCXO andthe standard frequency. MCU can determine and control the output of programmablepotentiometer using the control signal from PLL. By changing the output frequency ofOCXO, finally, OCXO can be locked to frequency standard. This method will retain theprevious frequency stability and phase noise of the OCXO, and the frequency regulationrange will be changed from 10? 7to 10? 6or even better.
引文
[1]赵声衡.《石英晶体振荡器》.1997年10月第1版.湖南大学出版社.1997年1月:150~159.
    [2] R.John. Vig. Quartz Crystal Resonator and Oscillator–For Frequency Control andTimingApplication.ATutorial. Jan. 1993;
    [3] M.E.Frerking. Fifty Years of Progress in Quartz Crystal Frequency Standards.Proceedings of the 1996 IEEE international Frequency Control Symposium. 1996,pages: 33-46;
    [4]黄秉英,周渭,张荫柏等.《测试计量技术手册第11卷-时间频率》.1996年10月第1版.中国计量出版社.1996年10月;
    [5]荆震.《高稳定石英晶体振荡器》.1975年7月第1版.国防工业出版社.1975年.
    [6]吴培才,刘进忙,胡国平.《温度补偿晶体振荡器》.1994年11月第1版.国防工业出版社.1994年11月;
    [7] Tomoki SHIODA, yoshifumi SEKINE and Hideo OTSUKA. High precision TCXOfor rapid environmental temperature change. Proceedings of the 2003 IEEEInternational Frequency Control Symposium and PDAExhibition, pages: 444-449;
    [8]彦美匀.低相噪恒温晶体振荡器的研制.电视技术,2004年第3期,149~152.
    [9]陈一新.调频晶体振荡器频偏扩展方法研究.武汉大学学报,2002年2月,第35卷第1期,80~83;
    [10]徐维涛,郝晓弘,杨新华.恒温晶振(OCXO)精密恒温箱温度控制电路分析.仪表计数与传感器,2005年第8期,41~43.
    [11]曾健平,章兢,晏敏,张红南,文剑.超小型高稳压控恒温晶体振荡器设计.in:计量技术,2003年第12期,19~21.
    [12] C.W.T.Nicholls and G.C.Carleton, Adaptive OCXO Drift Correction Algorithm.in:2004 IEEE International Ultrasonics, Ferroelectrics, and Frequency ControlJoint 50thAnniversaryConference. 2004. pp: 509-517;
    [13]周渭,欧晓娟,周晖,王海,屈八一.《时频测控技术》.2006年7月第1版,西安电子科技大学出版社,2006年7月.
    [14]张志涌.精通Matlab 6.5版.2003年3月第1版.北京航空航天大学出版社.2004年12月.
    [15] K. Weiss, B.Gniewinska, L.Nafalski. THE MODERN OCXO QUARTZOSCILLATORS REQUIREMENTS AND PARAMETERS, in: LFNM 2004. 6-9September 2004. Kllarkiv, Ukraine. pp: 209-212;
    [16]薛均义,张彦斌.《MCS51/96系列单片微型计算机及其应用》.1997年8月第2版.西安交通大学出版社.2002年3月:107~112;
    [17]戴佳,戴卫恒.《51单片机C语言应用程序设计实例精讲》.2006年4月第1版.电子工业出版社.2006年4月:136~162;
    [18]胡伟,季晓衡.《单片机C程序设计及应用实例》.2003年7月第1版.人民邮电出版社.2003年12月:299~312;
    [19]林庭双,柯常志.《Protel DXP电子电路设计精彩实例》.2005年10月.机械工业出版社.2005年10月.
    [20]常正阳,张志利.E2POT数字电位器X9241在电桥中的应用.仪器仪表用户.2005年第1期第12卷:35~37;
    [21] Company of Motorola. MECL system design handbook. Previous Edition 1980.printing august 2000;
    [22]方建邦,董献忱,王天玺.《锁相环原理及其应用》.1988年6月第一版,人民邮电出版社.1988年6月.
    [23]罗伟雄,韩力,丁志杰.《锁相技术及其应用》.1990年8月第一版,北京理工出版社.1990年8月.
    [24]刘书明,曹晓波.300MSPS高速10位D/A转换器AD9751.国外电子元器件.
    [25]刘爱荣,王振成,曹瑞,鲁印举.《EDA技术与CPLD/FPGA开发应用简明教程》,清华大学出版社,2007年.
    [26]罗朝霞,高书莉.《CPLD/FPGA设计及应用》.人民邮电出版社,2007年.
    [27]罗苑棠.《CPLD/FPGA常用模块与综合系统设计实例精讲》.电子工业出版社,2007年.
    [28]周渭,于建国,刘海霞.《测试计量技术基础》.2004年4月第1版.西安电子科技大学出版社.2004年4月.

© 2004-2018 中国地质图书馆版权所有 京ICP备05064691号 京公网安备11010802017129号

地址:北京市海淀区学院路29号 邮编:100083

电话:办公室:(+86 10)66554848;文献借阅、咨询服务、科技查新:66554700