文摘
Over the temperature range from 156 to 962¡ãC, the NPL maintains a series of heatpipe blackbody sources for the calibration of customer sources, radiation thermometers, and thermal imagers. The temperature of each of the sources is determined using a calibrated platinum resistance thermometer or gold-platinum thermocouple placed close to the radiating surface at the back of the cavity. The integrity of such a blackbody source relies on it having good temperature uniformity, a high and well-known effective emissivity, and having the sensor in good thermal contact with the cavity. To verify the performance of the blackbody sources, it is necessary to use an infrared thermometer that has been independently calibrated to compare the radiance temperature of the source with the temperature measured by the contact sensor. Such verification of the NPL blackbodies has been carried out at short wavelengths: from 500 to 1,000¡ãC using the NPL LP2 calibrated using the NPL gold point, and at 1.6 μm using an InGaAs-based radiation thermometer calibrated at a series of fixed-points from indium (156¡ãC) to silver (962¡ãC). Thermal imaging systems traditionally operate over the 3–5 μm waveband and are calibrated using NPL sources. Up until now, it has not been possible to verify the performance of the sources in this waveband except indirectly by cross-comparison of the sources where they overlap in temperature. A mid-infrared (nominally 3–5 μm) radiation thermometer has, therefore, been designed, constructed, and validated at NPL. The instrument was validated and calibrated using the fixed-point blackbody sources and then used to validate the heatpipe blackbodies over their temperature range of operation. The results of the instrument validation and blackbody measurements are given.
