摘要
通过对内贴应变片钢筋的直接拔出试验,分析钢筋直径、相对锚固长度(la/d)及混凝土相对保护层厚度(c/d)对塑钢纤维轻骨料混凝土与钢筋间粘结性能的影响,得出不同钢筋直径、锚固长度及相对保护层厚度对试件粘结锚固性能的影响规律,并提出塑钢纤维轻骨料混凝土钢筋锚固长度计算公式。试验结果表明:随钢筋直径的增大,试件粘结刚度增强,极限粘结强度先提高后降低;增加钢筋锚固长度会降低试件极限平均粘结强度,同时极限粘结强度对应钢筋自由端滑移量减小,试件粘结韧性则随锚固长度的增加而减小;混凝土相对保护层厚度增加会使试件极限粘结强度先提高然后趋于平稳。根据试验结果得到的钢筋锚固长度计算公式与规范给出的计算公式进行比较,从极限粘结强度的角度看,规范中的钢筋锚固长度计算公式偏于保守。
Through pull-out test of steel bars with strain gauges attached inside, the effect of bar diameter, la/d and c/d on the bond performance between steel bars and HPP fiber reinforced lightweight aggregate concrete was analyzed. The results of the pull-out test with different influential parameters showed that the bond stiffness between the bar and concrete was enhanced with the increase of steel bar diameter, and the ultimate bond strength was increased firstly and then decreased as the diameter was increased. The ultimate bond strength and corresponding free end displacement was reduced as the anchorage length was increased. The bond toughness declined as la/d was increased. The ultimate bond strength was increased firstly and then tended to become stable with the increase of the relative thickness of concrete cover. By comparing the bar anchorage length formula according to the test results with that given in the code, it was shown that the bar anchorage length formula in the code is conservative in terms of ultimate bond strength.
引文
[1]邓明科,寇佳亮,梁兴文,等.延性纤维混凝土剪力墙抗震性能试验研究[J].工程力学,2014,31(7):170―177.Deng Mingke,Kou Jialiang,Liang Xingwen,et al.Experimental investigation on aseismic behavior of ductile fiber reinforced concrete shear walls[J].Engineering Mechanics,2014,31(7):170―177.(in Chinese)
[2]Tuan B L A,Hwang C L,Lin K L,et al.Development of lightweight aggregate from sewage sludge and waste glass powder for concrete[J].Construction and Building Materials,2013,47:334―339.
[3]杨健辉,张鹏,王涛,等.全轻页岩陶粒混凝土三轴受压试验及其破坏准则[J].工程力学,2015,32(10):89―98.Yang Jianhui,Zhang Peng,Wang Tao,et al.The tests and failure criteria of full lightweight shale ceramsite concrete under true triaxial compression[J].Engineering Mechanics,2015,32(10):89―98.(in Chinese)
[4]Portal N W,Perez I F,Thrane L N.Pull-out of textile reinforcement in concrete[J].Construction and Building Materials,2014,71:63―71.
[5]Campione G,Cucchiara C,Mendola L L,et al.Steel-concrete bond in lightweight fiber reinforced concrete under monotonic and cyclic actions[J].Engineering Structures,2005,27(6):881―890.
[6]Iqbal S,Ali A,Holschemacher K,et al.Mechanical properties of steel fiber reinforced high strength lightweight self-compacting concrete(SHLSCC)[J].Construction and Building Materials,2015,98:325―333.
[7]Ghavidel R,Madandoust R,Ranjbar M M.Reliability of pull-off test for steel fiber reinforced self-compacting concrete[J].Measurement,2015,73:628―639.
[8]Kayali O,Haque M N,Zhu B.Some characteristics of high strength fiber reinforced lightweight aggregate concrete[J].Cement&Concrete Composites,2003,25(2):207―213.
[9]Güneyisi E,Gesoglu M,Ipek S.Effect of steel fiber addition and aspect ratio on bond strength of cold-bonded fly ash lightweight aggregate concretes[J].Construction and Building Materials,2013,47:358―365.
[10]孙立斌.塑钢纤维轻骨料混凝土与变形钢筋粘结性能的试验研究[D].包头:内蒙古科技大学,2015.Sun Libin.Research on bond properties between plastics-steel fiber reinforced lightweight aggregate concrete and deformed bars[D].Baotou:Inner Mongolia University of Science&Technology,2015.(in Chinese)
[11]Dahou Z,Sbarta?Z M,Castel A,et al.Artificial neural network model for steel-concrete bond prediction[J].Engineering Structures,2009,31(8):1724―1733.
[12]Ashrafi H R,Jalal M,Garmsiri K.Prediction of load–displacement curve of concrete reinforced by composite fibers(steel and polymeric)using artificial neural network[J].Expert Systems with Applications,2010,37(12):7663―7668.
[13]Tanyildizi H.Fuzzy logic model for the prediction of bond strength of high-strength lightweight concrete[J].Advances in Engineering Software,2009,40(3):161―169.
[14]GB 50010-2010,混凝土结构设计规范[S].北京:中国建筑工业出版社,1999.GB 50010-2010,Code for design of concrete structures[S].Beijing:China Architecture&Building Press,1999.(in Chinese)
[15]JGJ12-1999,轻骨料混凝土结构设计规程[S].北京:中国建筑工业出版社,1999.JGJ12-1999,Design specification of lightweight aggregate concrete structures[S].Beijing:China Architecture&Building Press,1999.(in Chinese)
[16]Garcia-Taengua E,Martí-Vargas J R,Serna P.Bond of reinforcing bars to steel fiber reinforced concrete[J].Construction and Building Materials,2016,105:275―284.
[17]Mahmoud Hassanpour,Payam Shafigh,Hilmi Bin Mahmud.Lightweight aggregate concrete fiber reinforcement-A review[J].Construction and Building Materials,2012,37:452―461.
[18]Kim D,Kim M S,Yun G Y,Lee Y H.Bond strength of steel deformed rebars embedded in artificial lightweight aggregate concrete[J].Journal of Adhesion Science Technology,2013,27(5/6):490―507.
[19]Kim Hung Mo,Johnson Alengaram U,Phillip Visintin,et al.Influence of lightweight aggregate on the bond properties of concrete with various strength grades[J].Construction and Building Materials,2015,84:377―386.
[20]Bogas J A,Gomes M G,Real S.Bonding of steel reinforcement in structural expanded clay lightweight aggregate concrete:the influence of failure mechanism and concrete composition[J].Construction and Building Materials,2014,65:350―359.
[21]李渝军,叶列平,程志军,等.高强陶粒混凝土与变形钢筋粘结锚固强度的试验研究[J].建筑科学,2006,22(4):51―55.Li Yujun,Ye Lieping,Cheng Zhijun,et al.Bond strength between high-strength lightweight aggregate concrete and deformed bar[J].Building Science,2006,22(4):51―55.(in Chinese)
